ALAMSCN LED Display Module TM1637 0.36” 4-Digit 7 Segment 4 Bits Red Digital Tube for Arduino Driver Board (Pack of 4)

Price: $7.99
(as of Jan 27,2022 22:09:54 UTC – Details)

Product Description



The module is a 12-pin 4-digit common anode digital tube (0.36 inch) display module with clock dots.

The driver chip is TM1637. Only 2 signal lines are required to enable the single-chip microcomputer to control a 4-digit 8-segment digital tube.


1. The display device is a 4-digit common anode red-digit digital tube, which can be used to display decimals, letters, etc.

2. The digital tube 8 grayscale adjustabley.

3. The control interface level can be 5V or 3.3V .

4. 4 * M2 screw positioning holes for easy installation.

Control port:

4 common anode score points

GND to ground

VCC for the power supply

DIO for the data input and output pins

CLK for the clock signal pin


Power supply voltage: DC 3.3V-5V

Module current: 30-80MA (when 5V power supply)

Positioning holes: 4 M3 screw positioning holes (hole diameter: 2.2mm)

Package Included:

4* 4-Bit LED Digital Tube Module

4-digit LED display module, red highlights, with adjustable LED brightness and clock point, can display decimals, letters, etc.
The driver IC is TM1637, compatible with Arduino.
The digital display tube can be controlled with only two signal lines, simple and easy to use.
Control interface: a total of 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin.
4 M2 screw holes, easy to install, locate and combine modules.

Leave a Reply

Your email address will not be published. Required fields are marked *